|
|
|
|
|
|
Acorn International WT-ST Wall Tie, 6-3/8 in L, 7/8 in W, Carbon Steel
|
|
|
Acorn International Wall Tie, Carbon Steel, 6-3/8 in Length, 7/8 in Width, 22 ga
|
|
|
|
|
|
|
|
|
|
Tamlyn BT22ZZSP Storage Strap, 6-3/8 in L, 7/8 in W, Galvanized Steel
|
|
|
Masonry accessory used to tie a brick veneer to the exterior of the house. Two holes provide for nailing on one end, other end is bent to lie between the mortar joints. Follow local codes for spacing. 6-3/8 in x 7/8 in.
|
|
|
|
|
|
|
|
|
|
Squeek No More 1011345 Floor Squeak Repair Screw
|
|
|
Specially scored waxed screws. Scored head breaks off at the same place every time. Carded.
|
|
|
|
|
|
|
|
|
|
Acorn International IHW16100 Insulation Support Wire, 16 in OAL, Carbon Steel
|
|
|
Secures batt-type insulation in place between joists. Chisel cut ends dig into joists for permanent holding. Easy to install in hard-to-reach crawl spaces. Pushes into place. Overall length is 1/2 in less than over center joist spacing. 13 ga.
|
|
|
|
|
|
|
|
|
|
Tamlyn PCS Series PCSL716 Framing Plywood Clip, 20 ga Thick Material, Steel, Galvanized
|
|
|
Tamlyn PCS Framing Plywood Clip, Steel, Galvanized, Material Thickness: 20 ga, Maximum Roof Span: 24 in, Number of PC per Spans: 1
|
|
|
|
|
|
|
|
|
|
Tamlyn PCS12 Framing Plywood Clip, 32 with PC, 28 without PC Roof Span, 20 Thick Material, Steel
|
|
|
Replace wood blocking on roof sheathing. Tight fit for positive installation. Embossed dimples provide 1/8 in gap needed to prevent panels from popping up as sheathing expands. G60 galvanizing finish. 20 ga, Boxed.
|
|
|
|
|
|
|
|
|
|
Tamlyn PCSL1532 Framing Plywood Clip, 20 ga Thick Material, Steel, Galvanized
|
|
|
Tamlyn Framing Plywood Clip, Steel, Galvanized, Material Thickness: 20 ga, Maximum Roof Span: 32, Number of PC per Spans: 1
|
|
|
|
|
|
|
|
|
|
Tamlyn PCS58 Framing Plywood Clip, 40 with PC, 32 without PC Roof Span, 20 Thick Material, Steel, Galvanized
|
|
|
Replace wood blocking on roof sheathing. Tight fit for positive installation. Embossed dimples provide 1/8 in gap needed to prevent panels from popping up as sheathing expands. G60 galvanizing finish. 20 ga, Boxed.
|
|
|
|
|
|
|
|
|
|
Squeek No More 1010543 Floor Squeak Repair Kit
|
|
|
The Squeek No More kit is designed to stop floor squeaks from above the floor by going safely through the carpet. The kit works on all carpets even berber. The Squeek No More kit has 50 screws that are scored one inch from the head and coated with a special wax that allows the screw to safely pass through the carpet. The tooling, a tripod fixture and driver bit, drives the screw safely through the carpet stopping the score on the screw slightly below the wood of the floor. Then with the tripod fixture you snap the head of the screw off. The screw thread then holds the floor to the joist without having any part of the screw sticking up that you could walk on. The kit also includes 2 joist finding tools. You use these to quickly and accurately find the joist from above the floor.
|
|
|
|
|
|
|
|
|
|
Acorn International IHW24100 Insulation Support Wire, 24 in OAL, Carbon Steel
|
|
|
Secures batt-type insulation in place between joists. Chisel cut ends dig into joists for permanent holding. Easy to install in hard-to-reach crawl spaces. Pushes into place. Overall length is 1/2 in less than over center joist spacing. 13 ga.
|
|
|
|
My cart:
